Table of Contents
What year Ford 460 had the most horsepower?
The first generation was introduced in 1968 and was produced until 1972, this had an Autolite four-barrel carburetor and made 365 horsepower and 485 pound-feet of torque. This is the most powerful of all of the 460s.
What years did Ford make the 460 engine?
From 1973 to 1978, Ford offered two versions of the 460 police engine.
How do I identify a Ford 460 engine?
The valve covers of the Ford 460 were marked with stickers. Examine the engine by pulling the old sticker off the intake manifold near the carburetor; then look for an engine identification tag with the engine logo attached to either the engine intake or coil near the ignition coil on the engine if there are new ones.
Are 460 engines reliable?
Thanks to its 30-year history, the 460 engine is very reliable. While there may be a few commonly encountered problems with oil coolers, water pumps, gaskets, and seals older than 20 years, they all seem to be caused by aging.
Is the Ford 460 a good motor?
Overall, Ford’s 7.5L 460 engine is extremely reliable. As is with any 25+ year old engine the majority of the problems associated with it today are from old age and high mileage. The block and major engine components themselves can easily withstand in excess of 300,000 miles.
Is the Ford 460 a good motorhome engine?
Drivers regarded the Ford 460 engine specs as one of the best engines for any vehicle, including a motorhome. The Ford 460 engine specs have always been powerful and reliable, regardless of the year it was built. It’s a reliable engine that can run for more than 250,000 miles without breaking down.
How can I tell if I have a 460?
460 I.D. Ford placed stickers on the valve covers identifying the engine as a 460. If the sticker is gone, or the covers have been replaced, look for a metal tag with engine identification attached to either the intake manifold in front of the carburetor, or to the ignition coil on the front of the engine.
What is the best year in a 460 Ford?
The 460 is a great motor because you can bore them and get CID much easier then a Chevy, the last 460 I built was out of a 1973 LTD, had a 1968 block (of which are capable of .110 over bore but sonic check walls to make sure)1968 rods. and thats all I kept, the best way to build a 460 is aaround the cyl heads, I had a set of 1970 429SCJ heads and thats what determind my cam pistons ect and at the time I built mine there wasnt much choice of parts like they have now, There is a company in Pa
Does Ford still make the 460 engine?
The Ford 460 big block engine has three-inch main bearings, notes Hot Rod Network. It first appeared in 1968 in Fords and Lincolns. Ford 460s were made until 1997, a run of 30 years. The engine was used in tugboat Lincolns up to 1978. Later, it was used in full sized Fords and Mercurys.
Which way does the distributor turn on a 460 Ford?
Locate the distributor, which will be near the top of the engine at either the front of back of the engine block. Loosen the distributor mounting bolt located at the base of the distributor, turning an adjustable wrench in a counterclockwise direction. Turn the distributor in a counterclockwise direction to advance the ignition timing.
How to tell what year 460 I have?
how do you tell the year or read the numbers on a 460 ford engine??? best way is to look up car vin- if you cant its usually has stamped numers (engraved) somewhere under all the grime- call your dealer they will let you know by the numbers 1 people found this helpful. there is a casting # on the block, heads, intake manifold etc.
https://www.youtube.com/watch?v=hiURVBOJro0